Keyence SJ-M200 Bedienungsanleitung

Before using this Compact Static Eliminator, be sure to thoroughly read this Instruction Manual.After you are finished with this Instruction Manual, b

93-3 Alarm Output FunctionsThis section describes the alarm output functions of the SJ-M Series.Alarm Output Functions Alarm output function (ALARM)T

103-4 Other Functions Relationship between installation distance and wind speed according to air flow rateThe relationship between wind speed and st

114-2Performing Maintenance on the Electrode probeWhen the SJ-M Series is used for a long period of time, the electrode probe becomes dirty due to the

125-2Specifications AC Adapter*The AC cable is for domestic use only (voltage rating 125 V).Model SJ-U2RatingRated input 100 to 240 VAC (50/60 Hz)Rat

131 TroubleshootingThis appendix describes trouble that may occur during use of the SJ-M Series and how to remedy thistrouble. Check the following tab

142Table of Indicated StatesThe condition alarm indicator lights (red).Condition alarmThe condition alarm indicator lights (red) when the ion balanceh

15WARRANTYKEYENCE products are strictly factory-inspected. However, in the event of a failure, contact your nearest KEYENCE office with details of the

1PrefaceThis document describes handling, method of operation and precautions when using the CompactSpot-type Static Eliminator SJ-M 100/200 Series.

2 Other Precautions•Be sure to read the WARNINGS and CAUTIONS described in each of theitems in this Instruction Manual.•This Static Eliminator has a

31-2Checking the Contents of the PackageThe package contains the following components and accessories. Before you start using the SJ-MSeries, make sur

42-1 Before InstallationThis section describes the static elimination performance of the SJ-M100/200 Series.Before you install the SJ-M100/200 Series,

52-1Before InstallationModel No. SJ-M020+SJ-MS3/ML3 (500 mm)Air flow rate 140 Nl/min (pressure0.3 MPa)Air flow rate 230 Nl/min (pressure0.5 MPa)Model

62-2 Connection and InstallationThis section describes how to connect and install the Static Elimination Head and Controller Unit.Installing the nozzl

72-2 Connection and InstallationAC adapter (SJ-U2)Connect the AC adapter to the connector on the side ofthe Controller Unit.The AC adapter is availab

83-1SJ-M Series Operations Tube Installation SettingAdvance to the tube head setting from the Select mode in page 7,and select either of the followin