Keyence CV-X Series Bedienungsanleitung PDF herunterladen (Seite 3)

358GB

KEYENCE CORPORATION. Vision System Division

‐ 3 ‐ www.keyence.com

✎Checking the Global Settings of the CV-X Series

On the "Global" menu, select [Communications & I/O] > [PLC-Link].

Select "OK" to close the "PLC-Link" setting screen and then restart the

controller.

Configure the PLC‐Link settings.

Mode: PLC- Link (RS- 232C)

PLC Type: MELSEC FX Series

Baud Rate: 19200

Stop Bit: 1

Parity Bit: Even

Flow Control: CTS/RTS

Data Length: 8- bit (fixed)

* The above is a setting example. Change the

settings according to the target device.

Decimal Point: Fixed- point

Command Execute Event: Polling

Command Complete Address (bit): 00003

Command Address: 00100

Command Result Address: 00200

Result Output Address: 00500

Result Ready Address (bit): 00000

Result Ack Address (bit): 00001

Acknowledge result output completion:

Checked

Enable Handshake: Unchecked

[Note] The memory range that can be used

varies according to the target device.

Furthermore, frequently accessing a memory

with EEPROM (non-volatile memory)

assigned may lead to delays, and a shorter

device lifespan.

Ensure that you have thoroughly checked

the memory range of the device to be

connected before using it.

1. Establishing the PLC-Link (RS-232C PLC-Link) [MELSEC FX Series]

This section describes how to establish the PLC‐Link.

[Important] If it fails, follow this manual to configure the settings and check the operations.

Confirm that it operates properly, and change settings if necessary.

1 2 3 4 5 6 7 8 ... 15 16

Keine Kommentare

Keyence CV-X Series Bedienungsanleitung Seite 3