
2. Overview and Operation
2
21
Note 3: Even the contact comments for ladder programs created with LADDER
BUILDER for KV Ver. 1.0x or KV-LADDER can be displayed on the KV-D20 after
being transferred to the KV unit with the LADDER BUILDER for KV Ver. 1.5 or
later.
Note 4: "Not transfer" is initially set as the contact comment transfer setting of the
LADDER BUILDER for KV Ver. 1.5 or later. To display contact comments on the
KV-D20, enable the contact comment transfer setting with the LADDER BUILDER
for KV Ver. 1.5 or later.
➮
Refer to the NEW KV Series User's Manual "Chapter 6 Software-Windows [KV-H6WE2]" on page
195.
When a system error occurs
The KV-D20 monitors only the communication status with the KV series.
When a system error occurs or communication is disabled in the KV unit, the KV-
D20 displays the message "TIME OUT ERROR".
Display language selection
The KV-D20 allows language selection from "English" or "Japanese" for the mes-
sages defined by the system of the KV series. The initial setting is English (Refer to
the table below).
To switch the display to Japanese, turn on special utility relay 2510.
Example
Display in system mode
RUN mode
PROG mode
Japanese display
English display
English display
Japanese display
hsilgnEesenapaJnoitpircseD
TESERP retnuocroremitafoeulavteserP
CED/CNI neercssseccatceridrofytitnauq)tnemerced(tnemercnI
MARGORPON
atadretalro0851MDotdeificepssi)0eulavro(gnihtoN
.yromem
EGNARFOTUO
fotuosiyromematadretalro0851MDrofeulavteserP
.egnarelbaliava
DESUNU
otdeificepssiretnuocdeeps-hgih/retnuoc/remitdesunU
.yromematadretalro0851MD
GORPotegnahC
)NURtixE(
edommetsysniGORPotNURmorfsegnahcneercS
NURotegnahC
)GORPtixE(
edommetsysniNURotGORPmorfsegnahcneercS
kv_d20_manual.p65 08.3.10, 6:08 PM21
Kommentare zu diesen Handbüchern