Keyence LS-5000 Bedienungsanleitung PDF herunterladen (Seite 41)

Chapter 6 Normal Mode

4 Limit Setup

7-level-tolerance-limits can be set separately for four outputs. (

➮

See p.41 for

setting output

■ Setting Procedure

1. Select the LIMIT SETUP screen.

Press the [LIMIT SETUP] button. The screen shown below is displayed.

2. Set tolerance limits.

Press the button corresponding to the output for which you wish to set tolerance

limits.

Select a desired tolerance limit using the [▲]/[ ] arrow keys.

Enter a value using the numeric keys, and press [ENTER].

Press [ESCAPE] to complete the entry.

Press [CANCEL] to cancel the entry. The value returns to the previous value.

Note 1: When a measured value exceeds the tolerance range, the measured value

is displayed in reverse. The differentiation result corresponding to the tolerance

limits is output from the display unit and the control I/O (option) board.

Note 2: Tolerance limits must conform to the following condition:

HI3 > HI2 > HI1 > LO3 > LO2 > LO1

Otherwise, the tolerance value cannot be entered. (The “ERR” message appears

on the display and the entered value cannot be accepted.)

Note 3: The maximum and minimum tolerance limit values are as follows:

Max.: 999.9999 (9.99999)

Min.: -99.9999 (-0.99999)

* Values in ( ) are the maximum and minimum values displayed in inches.

OUT1 • • • OUT4

LIMIT

SETUP

LASER ON SELECT OUTPUT

NOR

MAL

P. 1

DISPLAY

DATA

LIMIT

SETUP

PROGRAMCALIB

OPTIONS

OUT1

OUT2

OUT3

OUT4

Select Output No. to set the limits.

LIMIT SETUPOUT1LASER ON

NOR

MAL

P. 1

5 64

2 31

. -0

ENTER

CANCEL

ESCAPE

HI3 30.0000

HI2 25.0000

HI3 20.0000

LO1 15.0000

LO2 10.0000

LO3 5.0000

▲

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 131 132

Kommentare zu diesen Handbüchern

Keine Kommentare

Keyence LS-5000 Bedienungsanleitung Seite 41

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Keyence LS-5000